MobileView T750 Manual do Utilizador descarregar pdf (Página 8)

Publication 2727-GR001A-EN-P - September 2001

8 MobileView™ Tablet T750 Flash Update

Perform the Flash Update

Once communications are successfully established between the Tablet

and the host PC running HyperTerminal, the HyperTerminal screen

will present a Command List as shown below.

TIP

Before actually transferring the flash firmware image

file to the Tablet, you should make sure it is stored in

a location accessible to the host computer.

TIP

If the Command List does not appear on the

HyperTerminal screen, you should first confirm the

baud settings and port configuration of

HyperTerminal and then check the cable

connections between the Tablet and the host

computer. Next, close HyperTerminal and then

reopen it. If this does not resolve the problem, reset

the Tablet and make sure you press the

button-combinations as shown in Table A. If you still

cannot see the Command List after performing these

steps, contact Rockwell Automation for additional

assistance.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

MobileView T750 Manual do Utilizador Página 8